Blisstool LTC64 Betriebsanweisung PDF herunterladen (Seite 46)

In mode ORE, at work in manual ground balance mode (GROUND MODE = MAN),

after each change of the setting of potentiometer GROUND FINE, need again to be

made manual ground balance of the metal detector (from potentiometer GROUND

COARSE).

12.3. Switch AUTO ZONES of v6

Unlike from v5, which has three automatic stabilizers (with low, medium and high level of

stabilization), which can be selected by switch AUTO ZONES, v6 has only one automatic

stabilizer (with a very high degree of stabilization), as it always work with it, i.e.

therefore does not need its switching, switch AUTO ZONES at v6, has only one

function, as at v4, v3, v2i, v2 and v1, i.e:

/1/ To set one of the three available automatic ground zones at work in automatic ground

balance mode (switch GROUND MODE = AUTO). In manual ground balance mode (switch

GROUND MODE = MAN), this function of switch AUTO ZONES not working.

12.4. General conclusion for BLISSTOOL LTC64X (THE BEAST)

Compared to v5 of THE BEAST, v6 provides better work at heavy terrain conditions, such as:

highly mineralized terrains, terrains with a high content of ore, highly contaminated with iron

terrains, highly mineralized sands, but also better depth of detection at low and medium

mineralized terrains. These parameters can only be achieved with precision adequate setting

from users with a very good knowledge for the metal detector and the hobby metal detecting

as a whole. With medium levels of setting, v6 has parameters very similar to v5. Therefore v6

is recommended only for VERY EXPERIENCED users, which have the necessary

knowledge and skills to make the most of the power of THE BEAST v6 and which want

to have the BLISSTOOL metal detector with the best depth of detection until now. For

BEGINNERS, INTERMEDIATE and EXPERIENCED users, more suitable are v4 and v5.

BLISSTOOL LTC64X - User Guide (version EN201505131231) Page 46 of 62

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 61 62

Keine Kommentare

Blisstool LTC64 Betriebsanweisung Seite 46